Eos (1F7) V6-3.2L (BUB) (2008)
Suspension Strut / Shock Absorber: Removal and Replacement
Suspension Strut Removal and Installation
Suspension Strut
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G. 1332
^
Spreader 3424
^
Engine/transmission jack V.A.G. 1383 A
^
Mount T10149
Removing
^
Loosen drive axle bolt to wheel hub:
Note:
^
When doing this, vehicle must not stand on wheels, otherwise wheel bearing may be damaged.
^
Remove wheel.
^
Remove coupling rod hex bolt - arrow - from suspension strut.
^
Disengage wire for wheel speed sensor from suspension strut.
^
Remove nuts - arrows -.
^
Pull wheel bearing housing with ball joint out of control arm.
^
Pull drive axle outer joint out of wheel hub.
^
Secure drive axle to body using wire.
CAUTION!
Drive axle must not hang down, otherwise inner joint may be damaged when bent too far.
^
Bolt ball joint onto control arm again.