Eos (1F7) V6-3.2L (BUB) (2008)
^
Make sure that coil spring is seated correctly in 2 Spring Holders (80-165 mm) VAG1752/4 - arrow -.
^
Remove hex nut from piston rod.
^
Remove components of suspension strut and coil spring using spring compressor V.A.G. 1752/1.
Coil spring, installing
^
Place coil spring with spring compressor V.A.G. 1752/1 on lower spring plate.
End of spring coil must rest against stop - arrow -.
^
Tighten new hex nut to piston rod.
^
Relieve tension on spring compressor V.A.G. 1752/1 and remove from coil spring.
^
Suspension strut, installing.
Shock Absorber, Self-Leveling Suspension
Shock Absorber
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
Removing
-
Remove wheel.
-
Remove wheel housing liner.
For the Left Shock Absorber Only
-
Remove the left rear level control system sensor (G76) from the lower transverse link.
Continuation for Both Sides
-
Remove coil spring. Refer to => [ Coil Spring ] See: Suspension Spring ( Coil / Leaf )/Service and Repair/Removal and Replacement/Coil Spring.
-
Disconnect the connector and remove the wire from the shock absorber.