Eos (1F7) V6-3.2L (BUB) (2008)
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The bolted connections of the shock absorber to the wheel bearing housing must only be fastened when the dimension "a" is achieved! Refer to =>
[ Wheel Bearing, Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures.
Note the shock absorber installation position.
The left and right rear dampening adjustment valve (N338/N339) must point toward the outside of the rear wheel.
For the Left Shock Absorber Only
-
Mount the rear body acceleration sensor on the shock absorber mount
-
Mount the retainer on the shock absorber mount from the rear, so that the retainer tabs - 1 - fit into the depressions on the shock absorber mount.
-
Turn the retainer forward so that it contact the shock absorber mount.