Eos (1F7) V6-3.2L (BUB) (2008)
Seals and Gaskets: Service and Repair
Left Stub Shaft and Seal
Left Stub Shaft and Seal
Special tools, testers and auxiliary items required
‹› Slide hammer (VW 771)
‹› Pulling hook (VW 771/37)
‹› Thrust piece (3305)
‹› Torque wrench (VAG 1331)
‹› Torque wrench (VAG 1332)
Removing
‹› Transmission is installed.
-
Remove wheel and tire.
-
If fitted, remove center and left part of insulation below engine/transmission.
-
Turn steering fully to the left lock.
-
Remove drive axle from stub shaft.
-
Mark installation position of bolts - 1 -.
-
Remove bolts - 1 -.
-
Tie up drive axle as high as possible. Do not damage paint on drive axle when doing so.
-
Place a drain plan underneath the transmission.
-
Remove bolt for stub shaft, by installing two bolts into the stub shaft flange and counter holding the stub shaft using a pry bar.