Eos (1F7) V6-3.2L (BUB) (2008)
-
Install new bolts - 1 - to - 10 - hand-tight.
-
Tighten bolts in specified sequence to 5 Nm ± 90 degree (1/4 additional rotation).
-
Engage wire - A - first into top, then into bottom retaining tab - arrows -.
-
Connect and engage connector.
-
Replace both - O-rings -, if the old mechatronic is being installed again.
-
Coat the O-rings with DSG transmission oil.
-
Clean the cover gasket and sealing surfaces on the transmission.
-
Ensure correct seal seating.
-
Place cover over mechatronic without pinching any lines.
-
Install new bolts - arrows - and tighten diagonally in multiple stages to 10 Nm.