Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1080001.png)
Constant Velocity Joint: Service and Repair
Drive Axle With Triple Roller Joint AAR3300I
Drive Axle with Triple Roller Joint AAR3300i
Disassembling
^
Open both clamps at inner joint and slide back CV boot.
^
Pull off joint piece from drive axle.
^
Remove securing ring.
1 - Pliers (commercially available) - or VW 161 A
^
Insert drive axle in vise.
^
Press triple roller star off drive axle.
^
Pull off CV boot from shaft.
^
Clean shaft, joint and groove for oil seal.
Assembling
^
Slide small clamp for joint protective boot onto shaft.
^
Slide CV boot onto shaft.
^
Slide joint piece onto shaft.
Mount triple roller star
Conical drive axle
The chamfer on star faces toward shaft, this is used as an assembly aid.
^
Install triple roller star onto shaft and press on until stop.
^
Make sure pressure does not exceed 3.0 t!
^
If necessary, coat drive axle splines and triple roller star using solid lubricant G 052 142 A2.
^
Insert securing ring, be sure to fit properly.
As of 08.2004, a different grease will be used for triple roller joints. The grease must not be mixed with grease previously used. Therefore, triple roller
joint must be cleaned before greasing when performing service work.
^
Press 70 grams of joint grease from repair kit, into triple roller joint.
