Eos (1F7) V6-3.2L (BUB) (2008)
^
Slide joint piece over rollers and secure.
^
Press 60 grams of joint grease, from repair kit, into the reverse side of the triple roller joint.
^
Install CV boot.
Mount triple roller star
Cylindrical drive axle
^
Install triple roller star onto shaft and press on until stop.
^
Make sure pressure does not exceed 3.0 t!
^
Coat drive axle splines and triple roller star using solid lubricant G 052 142 A2 if necessary.
^
Insert securing ring, be sure to fit properly.
^
Press 70 grams of joint grease from repair kit, into triple roller joint.
^
Slide joint piece over rollers and secure.
^
Press 60 grams of joint grease, from repair kit, into the reverse side of the triple roller joint.
^
Install CV boot.
^
Install clamp.
Note:
^
Position crimping tab of clamp - arrow A - between mounting flanges of joint piece - arrows B - to facilitate threading of socket head bolts during
installation of drive axle.