Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove disc brake.
-
Now remove cover plate from wheel bearing housing.
-
Loosen nut of track rod ball joint, but do not unscrew yet.
‹› To protect thread, screw nut on pin a few turns.
-
Press off tie rod end from wheel bearing housing with ( 3287A) and then remove nut.
-
Press the drive axle out of the hub as far as possible (in direction of transmission).
-
Remove threaded connection of wheel bearing housing/suspension strut - arrow -.
-
Insert (3424) into wheel bearing housing slot.