Eos (1F7) V6-3.2L (BUB) (2008)
5
Cylinder Block
‹› Crankshaft overview. Refer to => [ Crankshaft Overview ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block
Assembly/Crankshaft/Service and Repair/Crankshaft Overview.
‹› Piston and connecting rod overview. Refer to => [ Pistons and Connecting Rod Overview ] See: Engine, Cooling and Exhaust/Engine/Cylinder
Block Assembly/Piston/Service and Repair/Pistons and Connecting Rod Overview.
6
Sealing Flange
‹› Apply sealant (D 176 501 A1) to the sealing surfaces.
7
Seal
‹› Remove using pulling hook (T20143/2).
‹› Polytetrafluoroethylene (PTFE) oil seal,
Identification: no inner coil spring
‹› Do not additionally lubricate or grease the sealing lip of the oil seal.
‹› Before installing, remove any remaining oil from the crankshaft with a clean cloth.
‹› Removing and installing, refer to => [ Crankshaft Seal, Transmission Side ] See: Engine, Cooling and Exhaust/Engine/Seals and
Gaskets/Crankshaft Main Bearing Seal/Service and Repair/Crankshaft Seal, Transmission Side.
8
Intermediate Plate
9
Dual Mass Flywheel
‹› Removing and installing, refer to => [ Dual Mass Flywheel ] See: Dual Mass Flywheel.
10
Bolt
‹› 60 Nm + 90° (1/4) additional turn
‹› Replace
‹› To loosen or tighten, use counter-holder tool (T10044) (with 5 mm spacers), or counter-holder tool (T10069).
11
Bolt
‹› 25 Nm