Eos (1F7) V6-3.2L (BUB) (2008)
-
Install the oil pump input shaft - A - all the way into the transmission. Turn the input shaft while doing this.
-
A new metal seal - B - must always be used.
‹› The 2 alignment pins - C - must be located in the transmission housing.
-
When positioning the oil pump, pay attention to the input shaft splines and correct seating on the alignment pins.
Various Oil Pump Bolts - 1 -
All 4 bolts with flat heads
Tightening specification:
‹› 5 Nm + 90° (1/4) additional turn
3 bolts have flat heads, the upper bolt is countersunk