Eos (1F7) V6-3.2L (BUB) (2008)
Tightening specification:
‹› Countersunk bolt: 8 Nm without tightening angle (tighten using (T10054))
‹› Flat head bolts: 8 Nm + 90° (1/4) additional turn
-
Set the new oil pump cover - A - in place and tighten the new bolts - arrows - in a diagonal sequence and in multiple stages to 8 Nm.
Transmission does not have oil. You must now add new oil and adjust to the correct oil level.
-
Replace the oil and filter. Refer to => [ Oil Filter, Changing and Oil Level, Adjusting ] See: Automatic Transmission/Transaxle/Fluid Filter -
A/T/Service and Repair/Oil Filter, Changing and Oil Level, Adjusting.
-
Install the left front wheel housing liner.
-
Install the noise insulation.