Eos (1F7) V6-3.2L (BUB) (2008)
-
Install the flange shaft.
-
Install the flange shaft bolt and tighten it to 30 Nm.
-
Instal the ball joint to lower control arm bolts/nuts to the old impressions.
-
Install the left drive axle to the flange shaft.
-
Install the left front wheel housing liner.
-
Install the left wheel.
-
Change the Direct Shift Gearbox (DSG) oil. Refer to => [ Oil Filter, Changing and Oil Level, Adjusting ] See: Automatic
Transmission/Transaxle/Fluid Filter - A/T/Service and Repair/Oil Filter, Changing and Oil Level, Adjusting.
-
Install the noise insulation.