Eos (1F7) V6-3.2L (BUB) (2008)
Control Module: Testing and Inspection
CAN-Bus Terminal Resistance, Direct Shift Gearbox (DSG) Mechatronic J743 To Engine Control
Module (ECM) J623, Checking
CAN-Bus Terminal Resistance, Direct Shift Gearbox (DSG) Mechatronic J743 To Engine Control Module (ECM) J623, Checking
Special tools, testers and auxiliary items required
-
Multimeter.
-
Wiring diagram.
Test requirement
-
A CAN-Bus malfunction was recognized.
-
The Engine Control Module (ECM) J623 Direct Shift Gearbox (DSG) Mechatronic J743 fuses OK.
-
The Direct Shift Gearbox (DSG) Mechatronic J743 fuses OK.
-
Battery voltage at least 12.5 volts.
-
All electrical consumers such as, lights and rear window defroster, switched off.
-
Vehicles with automatic transmission, shift selector lever into position "P" or "N".
-
A/C switched off.
-
Ground (GND) connections between engine/transmission/chassis OK.
-
Ignition switched off.
Function
The Engine Control Module (ECM) J623 communicates with other CAN-Bus capable control modules.
The control modules are connected by two data bus wires which are twisted together (CAN_High and CAN_Low), and exchange information
(messages). Missing information on the CAN-bus is recognized as a malfunction by the Engine Control Module (ECM) J623 and the other control
modules connected to the CAN-bus.
Trouble-free operation of the CAN-Bus requires that it have a terminal resistance. This central terminal resistance is located in the Engine Control
Module (ECM) J623.
Test procedure
-
Perform a preliminary check to verify the customers complaint. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Preliminary Check
Start diagnosis
-
Disconnect the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector.
NOTE:
-
The Engine Control Module (ECM) J623 must remain connected for the following step.
-
Using a Multimeter, check the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector terminals 10 to 15 for resistance.
Specified value: 60 to 72 Ohms (at approx. 20 degrees C)
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Engine Control Module (ECM) J623.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin VAG1598/31.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) J623.
-
Using a Multimeter, check the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector to the Engine Control Module (ECM)