Eurovan L5-2459cc 2.5L SOHC (1992)
-
Remove inner sections of clips - 1 - with Allen wrench.
-
Pry off cap - 2 -, remove hex bolt with washer.
-
Remove recessed screw - 3 -, carefully pry out belt guide with locking panel - 4 -.
-
Loosen molded trim at rear in area of overlap with side panel molded trim front.
-
Unclip side panel molded trim front, in following order:
-
B - pillar - arrow A -
-
Window pillar - arrow B -
-
Pull off front of side panel molded trim, near B-pillar, push as far as possible in direction of travel.
-
Disconnect connector for 12 V Socket - U5 -.
-
Pull off molded trim - top - near table - 1 - mount, fold down mount and lift molded trim over bottom support - 2 -.
Front molded side panel trim, installing