Eurovan L5-2459cc 2.5L SOHC (1992)
Windshield, Side And Rear Window, Installing
Windshield, Side And Rear Window, Installing
-
Prepare unbroken window for installation.
-
Prepare new window for installation.
-
Prepare body flange for installation.
Installation notes
Curing time
Body Flange And/or Window Flange on Door, Preparing
Body Flange And/Or Window Flange On Door, Preparing
-
Cut back remaining adhesive material on body flange to 1 to 2 mm (1/32 to 5/64 in.) height with electric cutting tool VAG 1561 and scraping
knife VAG 1561/8.
NOTE: Do not remove adhesive completely. It is used as a base for new adhesive material.
CAUTION: Do not prime or activate adhesive surface or treat it with cleaning solution. Keep adhesive surface dirt and grease free.
Exception:
If gluing will not take place immediately after cutting back, remaining residual material must be activated with activator AMV 181 800 02 or equivalent.
-
If body flange at area of glass is being worked on or replaced flange must be cleaned and primed after painting.
New Window Installation, Preparing
New Window Installation, Preparing
-
Clean edge of window around to width of about 30 mm (approx. 1.2 in.) with cleaning solution D 009 401 04 or equivalent and wipe dry with
lint-free cloth.
-
Install molding - 1 - window.
CAUTION: Ceramic application on window Is not primer. Priming must be done before applying adhesive sealing compound Use only
primer D 009 200 02 or equivalent.
-
Using applicator D 009 500 25 or equivalent - 3 -, apply primer - 2 - evenly in one continuous motion.
-
Drying time approx. 10 minutes