Eurovan V6-2800cc 2.8L (AES) (2000)
02 - Check DTC memory
-
Press -Q- button to confirm input.
The number of stored malfunctions appears in the display.
X DTC recognized!
->
The number of stored DTCs or "No DTCs recognized" appears in the display and are printed out one after another.
-
When the last DTC has been displayed and printed out, rectify malfunctions as described in DTC table: See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/VAG Code Charts/Radio System/Factory
Installed Units/About Trouble Codes
If "No DTC recognized" is displayed, the program will return to the initial position after pressing -> button.
No DTC recognized!
->
Indicated on display (select function):
Rapid data transfer
HELP
Select function XX
If display not indicated as shown:
See Scan tool operating instructions
-
End output (function 06).
-
Switch off ignition and disconnect Data Link Connector (DLC).
NOTE:
If DTCs were recognized, follow the sequence below:
1. Rectify malfunction.
2. Erase Diagnostic Trouble Code (DTC) memory (function 05).
3. Check Diagnostic Trouble Code (DTC) memory (function 02).
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for reading diagnostic trouble codes without a scan tool.
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Erasing (Function 05)
NOTE: Erasing DTC memory (function 05) is only possible after checking DTC memory (function 02). If DTC memory cannot be erased, check DTC
memory again and rectify indicated malfunctions.
Prerequisites
-
Check DTC memory.
-
All malfunctions repaired.
After checking DTC memory:
Readout in display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -5- to select function 05, "Erase DTC memory".
Readout in display:
Rapid data transfer
Q
05 Erase DTC memory
-
Press -Q- button to confirm input.
Indicated on display: (DTC Memory is erased)