Eurovan V6-2800cc 2.8L (AES) (2000)
Oil Spray Jet: Service and Repair
Component Notes And Information
NOTE:
^
During service procedures, refer to the illustration above and the information below.
^
If metal shavings or large quantities of metal particles (possibly caused by partial seizure of crankshaft and connecting rod bearings) are found in
the engine oil while performing engine repairs:
^
Thoroughly clean all oil passages, replace all oil spray jets, the oil non-return valve and the oil cooler
1
Bolt
-
Tighten to: 10 Nm (7 ft lb)
2
Oil pump drive cover
3
O-ring
-
Always replace
-
Oil before installing
4
Oil pump drive
5
Intermediate shaft
6
Thrust washer
7
Bolt
-
Tighten to: 10 Nm (7 ft lbs)
-
Install with locking fluid "D6"
8
Oil pump
-
Disassembly and assembly. See: Oil Pump/Service and Repair
-
Coat oil pump housing and oil pressure pipe at cylinder block using AMV 188 001 02
9
Bolt
-
Tighten to: 25 Nm (18 ft lb)
10
Bolt
-
Tighten to: 10 Nm (7 ft lb)
-
Always replace
-
Install with "D6" locking fluid
11
Oil drain plug
-
Tighten to: 30 Nm (22 ft lb)
12
Seal
-
Always replace
13
Oil spray jet
-
For crankshaft bearings 2 to 7
-
For piston cooling
-
Removing and installing, refer to Fig. 1 below
-
Opening pressure: 2.0 bar
14
Bolt
-
Tighten to: 15 Nm (11 ft lb)
-
Remove and install using 3249 socket