Eurovan V6-2800cc 2.8L (AES) (2000)
Special tools, testers and auxiliary items
-
VAG 1332 Torque wrench 40 to 200 Nm (30 to 148 ft lb)
-
3268 Crankshaft setting bar
Work Sequence
-
Set crankshaft to TDC cyl. 1 marks -arrow- by turning crankshaft (via vibration damper mounting bolt) in direction of engine rotation
-
Position camshafts using 3268 camshaft jig
NOTE: This orientation is only possible every 2nd TDC position.
-
Install cylinder head gasket
-
Note position of centering sleeves (in block holes 12, 20)
-
Install cylinder head
-
Insert cylinder head bolts and tighten by hand
-
Tighten cylinder head using four stage sequence as follows:
Tighten initially using torque wrench
Stage I: 40 Nm (30 ft lb)
Stage II: 60 Nm (44 ft lb)
Turn further using ordinary wrench
Stage III: 1/4 turn (90°) additional
Stage IV: 1/4 turn (90°) additional
NOTE:
^
Loosening cylinder head: reverse sequence
^
Torquing cylinder head after repairs is not necessary