Eurovan V6-2800cc 2.8L (AES) (2000)
/Page-369010.png)
^
Attach separator (1) behind bearing inner ring (2).
Installation position: Beveled part of blades faces bearing inner ring.
^
Put on bell (3) and hollow piston cylinder (4) with tie bolt, screw on with special nut (5), and pull off bearing inner ring.
1 - 17/2 Kukko separating tool
2 - bearing inner ring
3 - Bell E-40
4 - Hollow piston cylinder HKZ-15
5 - Special nut E-8-214 and tie bolt
Pressing in wheel bearing
Installation position: Greater inside diameter of wheel bearing faces out.
^
Put wheel bearing (1), pressure piece (2) (put collar into bearing), and hollow piston cylinder (3) with tie bolt on wheel bearing housing.
^
Attach pressure piece (4) with angles toward wheel bearing housing and special nut (5) from inside.
^
Press in wheel bearing by actuating pump.
^
Install securing ring.
1 - wheel bearing
2 - pressure piece E-51 (T)
3 - Hollow piston cylinder HKZ-15
4 - pressure piece E-31 (T)
5 - Special nut E-8-214 and tie bolt
Pressing in wheel hub
