Eurovan V6-2800cc 2.8L (AES) (2000)
Air Injection Control Valve: Service and Repair
Component Notes And Information
NOTE:
^
During service procedures, refer to the illustration above and the information below.
^
Components marked with an * are checked by On Board Diagnostic
^
Components marked with ** are checked via Output Diagnostic Test Mode (DTM)
^
Secondary Air Injection pump relay -J299-**, refer to Fig. 1 below
1
Air port
-
In cylinder head
2
0-ring
-
Always replace
3
Connection
4
Bolt
-
Tighten to: 15 Nm (11 ft lb)
5
0-ring
-
Replace if damaged
6
Bolt
-
Tighten to: 25 Nm (18 ft lb)
7
Bracket
-
For Secondary Air Injection pump motor
-
Mounted to intake manifold
8
Retainer
-
For Secondary Air Injection solenoid valve
9
Bolt
-
Tighten to: 10 Nm (7 ft lb)
10
2-pin harness connector
-
Black for Secondary Air Injection solenoid valve
11
Vacuum pipe
-
To junction piece between intake manifold and fuel pressure regulator
12
Secondary Air Injection Solenoid valve (-N112-) */**
13
2-pin harness connector
-
Black
-
For Secondary Air Injection pump motor
14
Secondary Air Injection pump motor (-V101-)**
15
intake hose