Eurovan V6-2800cc 2.8L (AES) (2000)
-
Connect VAG 1598/18 Test Box to ECM harness connector.
-
Remove Secondary Air Injection pump relay (arrow 1) from fuse/relay panel.
NOTE:
-
If tools are required to remove relays or Control Modules from the fuse/relay panel; first disconnect the battery ground cable.
CAUTION: Obtain the radio anti-theft code before disconnecting the battery ground cable!
-
Using wiring diagram, check for open circuit between Test Box socket 49 and terminal 4 of fuse/relay panel.
-
Resistance: 1.5 Ohms maximum.
If wiring OK:
-
Check relay voltage supply using wiring diagram, replace relay if necessary. Replace Secondary Air Injection pump relay J299 if necessary.
If relay OK:
-
Replace ECM J220.
-
Press -> button
Display will appear as shown:
"Output Diagnostic Test Mode" --->
EVAP Canister Purge Solenoid Valve N115
CAUTION: Disregard this display! It does not apply to this vehicle.
-
Press -> button
Display will appear as shown:
Rapid Data Transfer HELP
Select Function XX
When you have completed "Output Diagnostic Test Mode" checks: