Eurovan V6-2800cc 2.8L (AES) (2000)
/Page-50002.png)
Display Group 98
NOTE:
If the basic setting of the control module is interrupted, the cause could be one of the following:
-
The throttle valve cannot reach the mechanical stop because of contamination (e.g. oil deposits) or an incorrectly adjusted throttle cable.
-
The battery voltage is too low.
-
The throttle valve control module or wiring is faulty.
After an abort the DTC 17967 is stored in the DTC memory. When next switching on the ignition the basic setting is automatically performed again.
-
End engine basic setting at earliest after 30 seconds by pressing the -> button.
-
Press buttons -0- and -6- to select "End output" and confirm entry with -Q- button.
