Eurovan V6-2800cc 2.8L (AES) (2000)
/Page-72001.png)
Engine Control Module: Service and Repair
Replacement of ECM & Control Module For Immobilizer Adaptation
Replacement Of Engine Control Module (ECM) And Control Module For Anti-theft Immobilizer -J362-, Adaptation (function 10)
If all components are to be replaced, adapt all control modules and use new key set.
Appropriate control modules must be obtained from the parts department based on the Vehicle Identification Number (VIN) and engine code.
Appropriate ignition keys must be obtained from the parts department based on the key number.
-
Install new components.
-
Before adapting components, the VIN must be input in to the control module for immobilizer. This is only possible with the VAS 5051 tester.
-
Adapt Engine Control Module (ECM).
-
Adapt all ignition keys.
Engine Control Module (ECM), Replacing
The Engine Control Module (ECM) is in the engine compartment on the left side near the vehicle battery mounting.
The ECM regulates the injection, throttle valve control module, oxygen control, ignition, knock control, EVAP purge regulator solenoid valve 1, the
Leak Detection Pump, the engine speed governor via the injectors or fuel pump relay, the charge pressure control and On Board Diagnostic (OBD).
Special tools and equipment
-
VAG 1551/1552 Scan Tool using VAG 1551/3 adapter cable
Work sequence
-
Connect VAG 1551 (VAG 1552) Scan Tool.
-
With ignition switched on but engine not running, press buttons -0- and -1- to select "Engine electronics" address word 01.
The VAG 1551 scan tool display will show the control module identification
021 906 259B MOTRONIC M5.9 AT V01 ->
Coding 0000
wsc xxxxx
-
Press PRINT button on VAG 1551 and print out control module identification.
-
Press -> button.
-
Press buttons -0- and -6- to select "End output" and confirm input with -Q- button.
Display will appear as shown
Rapid data transfer
HELP
Select function XX
-
Switch ignition off..
-
Remove cover for control module connector in upward direction.
