Eurovan V6-2800cc 2.8L (AES) (2000)
^
Mark installation position on inner bearing bracket
^
To remove, unhook spring for brake pressure regulator at balance arm
^
Adjust brake pressure regulator when replacing
^
If necessary, protect new control arm with cavity preservation against corrosion
^
Hold in installation position when tightening bolts.
19 - Outer rubber bushing
^
Pulling out go to Fig. 1
^
Pulling in go to Fig. 2
20 - Nut, 160 Nm
21 - Hex bolt, 100 Nm
22 - Shock absorber
^
Allocation
^
Check shock absorber for leaks and noises
^
Identification: black = original gray = original green = reinforced
23 - Rubber bearing
24 - Washer
^
Collar points to shock absorber
25 - Hex bolt, 45 Nm
26 - Upper backing plate
^
Turn so that the end of the spring is in the depression
27 - Stop buffer
^
Allocation
28 - Coil spring
^
On all wheel drive, unbolt drive axle on transmission side
^
Installation position go to Fig. 3
^
Check for paint damage, repair if necessary
29 - Cap
^
Allocation
30 - Socket head screw 10 Nm
31 - ABS wheel speed sensor
^
Before inserting sensor, clean inner surface of bore hole and coat with securing grease G 000 650
32 - Shock absorber buffer
^
Allocation
33 - Wheel bearing
34 - Inner mounting bracket
^
With horizontal longitudinal holes for toe setting.
35 - Mounting bracket
36 - Pop rivet
37 - Outer mounting bracket
Fig. 1 Pull bonded rubber bushings out from drive axle
^
Clamp drive axle into vice.
^
Insert a disc between nut and bearing (arrow) and coat with oil.
^
Pull out bonded rubber bushings.