Eurovan V6-2800cc 2.8L (AES) (2000)
-
Removing and installing refer to Fig. 1 below.
10
Piston cap
-
Sealing lips are vulcanized to cap
-
Moisten sealing lips with ATF before installing
-
Turn cap slightly when installing
11
Intermediate spring ring
-
With spring supporting shell and compression springs
12
Piston
-
Sealing lips are vulcanized to piston
-
Moisten sealing lips with ATF before installing
-
Turn piston slightly when installing
13
Clutch housing
-
Before installing the inner plate carrier corrugated washer (item 8), insert inner and outer plates in the clutch refer to Fig. 3 below.
Procedures
Fig. 1 Circlip, Removing And Installing
-
Press piston cap with intermediate spring ring down far enough for circlip -arrow- to be inserted in groove.
Fig. 2 Thrust Plate And Plates, Installing Onto Inner Plate Carrier
-
Install thrust plate -a- with smooth side facing inner plate and stepped side towards inner plate carrier.
-
Install 3 inner plates -b- and 2 outer plates -c-.
-
Clip in supporting ring with step -arrow-.
NOTES:
^
Locate lugs correctly
^
Installing corrugated washer and further plates in clutch housing, refer to Fig. 3 below.
Fig. 3 Corrugated Washer And Inner And Outer Plates, Installing In Clutch Housing
-
Install corrugated washer.
-
Install 2 mm thick outer plate.
-
Install remaining inner and outer plates.