Eurovan Camper V6-2.8L (AXK) (2002)
NOTE: The terminal housing 1J0 972 751 comes with the wiring harness assembly
IMPORTANT: To insert the B+ terminal into the 1J0 972 751 housing, the side clip needs to be opened
NOTE: This terminal housing -11- will be connected to a terminal housing -2- on the new wiring harness later in the procedure
-
From the rear of the upper half of the relay panel, insert the new relay connector block on the new harness assembly into position #9 -arrow-
NOTE: The new relay must be removed from the relay connector on the new harness assembly before installing
-
Route wires 2, 6 and 8 on the new harness assembly behind the fuse/relay panels
-
Locate terminal -8- (arrow) on the new wiring harness assembly
-
Insert terminal 8 on the new wire harness into the empty (B+) location in the 15 amp fuse holder -arrow-