Eurovan MV V6-2.8L (AXK) (2002)
With CD changer loosely installed:
-
Tighten all seat mounting bolts to hold CD changer in place (see VESIS repair group 72, Front seat and frame, removing, for correct torque
specifications).
-
Tighten 6 mm nuts to fasten CD changer to floor mounting brackets.
-
Connect CD changer to harness (position excess harness on side of CD changer).
Radio, coding to accept CD changer
Note:
Radio will control CD changer regardless, however, for proper operation and diagnostics, code the radio for CD support.
-
Connect the VAS 5051 Diagnostic tool.
-
Code radio to accept CD changer by changing last digit in code from 0 to 2 (see VESIS Group 01 Radio, On Board Diagnostic (OBD) 08.98 > for
coding procedure).
-
Test CD changer operation with a CD. With CD changer operational:
-
Finish installation by bundling any excess wiring harness behind carpet as shown.
-
Ensure that wiring harness will not rattle by fastening with tape where necessary.
-
Reinstall close-out cover below instrument panel (passenger side).
-
For MultiVan, reinstall rearward facing seat.