Eurovan MV V6-2.8L (AXK) (2002)
Front axle: 50 bar (725 psi)
Rear axle: 20 ± 2 bar (290 ± 29 psi)
-
Adjust if necessary as outlined below.
-
Continue with adjusting buffer stops as outlined below.
Adjusting Brake Pressure
-
Turn both buffer stops -1- back onto stop (downward).
-
Mark spring mounting -2- position with a felt tip pen or tape on control arm.
-
Loosen bolt -3- and move mounting -2-.
NOTE:
^
Moving spring mounting -2- downward increases pressure.
^
Moving spring mounting -2- upward decreases pressure.
^
It is only necessary to adjust the position of the second spring mounting -2- if the horizontal beam 4- is excessively inclined (more than 4 mm,
refer to arrows).
^
Moving the spring mounting -2- 1 mm equates to a pressure change of approx. 4 bar (58 psi) at the rear axle.
^
Slight inclination of the horizontal beam -4- is permissible (max. 4 mm between left and right refer to arrows).
-
Tighten bolt -3-, counter-hold when tightening.
-
Correct brake pressure regulator setting at second spring mounting -2- if necessary.
-
Continue with adjusting buffer stops as outlined below.
Adjusting Buffer Stops
NOTE: Check whether the securing clip, item -2- is securely seated, refer to illustration in Replacement. See: Service and Repair
-
Check brake pressure (if not already checked) as outlined above.
-
If setting is OK, insert pedal depressor.
-
Hold front axle brake pressure to at least 50 bar (725 psi).