Eurovan MV V6-2.8L (AXK) (2002)
-
Look for and observe all HIGH VOLTAGE! warning stickers. Discharge residual voltage at applicable components before performing repairs.
CAUTION!
-
All wiring harness and connector repairs must only be performed using repair kit VAS 1978!
-
Observe all repair instructions, CAUTIONS and WARNINGS pertaining to electrical system/component repairs.
-
Before beginning wiring and connector repairs, determine and rectify the cause of damage, eg.: pinched between metal parts, malfunctioning
electrical consumers, corrosion due to water ingress etc.
-
Soldering is NOT permitted to any vehicle wiring.
-
Do not repair welded connections in wiring harnesses. If necessary, fabricate overlay wiring harness.
-
All shielded wiring (eg.: knock sensors, antenna etc.) are not to be repaired! Replace complete wiring harnesses as necessary.
-
When repairing airbag and seat belt tensioner wiring harnesses, use only prescribed terminals, connectors and wiring.
-
Only the yellow repair cables and insulation tape supplied with VAS 1978 are to be used for wiring/connector repairs. The use of yellow repair
wires and yellow insulation tape identifies that a repair has taken place!
-
To prevent corrosion, avoid removal of ground connections at body fix-points.
-
When repairs are completed, always perform a functional check of the component or system. Where applicable, check and erase Diagnostic
Trouble Codes (DTCs) and set basic setting.
-
Additional information on removal and installation of electrical and related components.