Eurovan MV V6-2.8L (AXK) (2002)
Adaptation
->
Adaptation values have been erased
-
Press -> button.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Switch off ignition.
-
Within 60 seconds, switch ignition on.
NOTE: The next time the ignition is switched on, ECM and immobilizer control module recognition is read and saved. After which, starting the engine
should only be done after approximately 2 minutes.
Engine Control Module (ECM), Coding
Code Control Module (Function 07)
NOTE:
-
During control module identification, a 5-digit code must always be indicated.
-
If control module does not indicate coding corresponding to vehicle, or if control module has been replaced, code it as follows.
Special tools and equipment
-
VAG1551 Scan Tool (ST) with VAG1551/3B cable
Procedure
-
Connect VAG1551 scan tool (VAG1552). Then switch ignition on and select the Engine Control Module (ECM) using address word 01.
Connecting scan tool and selecting ECM.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press 0 and 7 for the function "Code Control Module", and then press Q to exit from input mode.
Indicated on display:
Code control module
Enter code number XXXXX
(0-32000)
-
Enter appropriate code number for this vehicle, and press Q to exit from input mode.
Coding versions:
NOTE: The code number is put together as shown in the following example: