Eurovan MV V6-2.8L (AXK) (2002)
Intake Air Temperature Sensor: Testing and Inspection
Intake Air Temperature (IAT) Sensor, Checking
NOTE: The Intake Air Temperature (IAT) sensor -G42- is a component of the Mass Air Flow (MAF) sensor -G70- and cannot be replaced individually.
Special tools and equipment
-
VAG1551 scan tool (or VAG1552 mobile scan tool) with VAG1551/3B cable
-
VAG1598/31 test box
-
VAG1526 multimeter or VAG1715 multimeter
-
VAG1594 connector test kit
-
Wiring diagram
-
VAG1921 hose clip pliers
-
Chilling spray (commercially available)
Test sequence
NOTE: When servicing terminals in the harness connector for the Intake Air Temperature (IAT) sensor, use only gold-plated terminals.
-
Connect VAG1551 scan tool (VAG1552). Then switch ignition on and select the Engine Control Module (ECM) using address word 01.
Connecting scan tool and selecting ECM. Refer to " Scan Tool Testing/Scan Tool Connecting and Initial Checks " See: Testing and Inspection
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read measuring value block" function 08. Press -Q- button to confirm input.
Indicated on display:
Read measuring value block
Enter display group number XXX
-
Press 0, 0 and 4 for the function "display group number 4", and then press Q to exit from input mode.
Indicated on display: (1 to 4 = display fields)
Read measuring value block 4
->
1
2
3
4
-
Read Intake Air Temperature (IAT) value in display field 4.