Eurovan MV V6-2.8L (AXK) (2002)
-
Disconnect connector from all ignition coils -1-
-
Using Puller T10095, remove ignition coils
CAUTION: USE OF TOOL T10095 IS REQUIRED TO AVOID DAMAGING THESE SENSITIVE COMPONENTS
NOTE: Only ignition coils that are not one of the production levels shown in "Parts Information" must be replaced
-
Install new ignition coils (022 905 100D/G/K) by pressing into cylinder head by hand only
IMPORTANT:
-
Do not use any object to tap ignition coil into position
-
Do not twist ignition coil when installing
-
Reconnect connectors to ignition coils
-
Reinstall engine cover
-
If vehicle is a 2002 model year Jetta with automatic transmission go to Section A1
-
If vehicle is a 2003 model year Jetta with automatic transmission go to Section A2
-
If vehicle is a Jetta or GTI with manual transmission go to Section A3
Section A1 - Wiring Harness Modification on 2002 Model Year Jetta Vehicles having a 2.8 Liter Engine with an Automatic Transmission
-
Disconnect battery ground (GND) cable
-
Remove relay cover -arrow- for relay panel (located next to brake booster) in engine compartment
-
Remove fuse (S51) -white arrow- for vacuum pump from fuse holder
-
Remove relay #428 for the main power supply to the engine control module (ECM) -black arrow-
-
Lift out relay panel from the lower housing