Eurovan MV V6-2.8L (AXK) (2002)
-
Connect VAG1598/31 test box to control module wiring harness. Engine Control Module (ECM) is not connected.
-
Check for open circuits in wires between test box and connector according to wiring diagram.
Terminal 1 + socket 98
Terminal 2 + socket 86
Terminal 3 + socket 108
Wire resistance: max: 1.5 Ohms
-
Also check wires for short circuit to each other. Specification: Infinity Ohms
If no malfunctions are found in the wires and there was voltage between terminals 1 + 3:
-
Replace Camshaft Position (CMP) sensor -G40-.
Test sequence for Camshaft Position (CMP) sensor 2 -G163- (exhaust camshaft)