Eurovan MV V6-2.8L (AXK) (2002)
Alarm Module: Programming and Relearning
Control Module For Anti-theft Immobilizer -J362-, Coding (function 07)
Immobilizer III with control module data exchange via CAN Bus, coding control module
-
Press buttons -0- and -7- to select function 07, "Code Control Module".
Indicated on display:
Rapid data transfer
Q
07 - code control Module
-
Press -Q- button to confirm input.
Indicated on display:
Code control module
Enter code numbers XXXXX
(0-32000)
-
Only one code is possible for all EuroVan: 00001
Indicated on display:
Code control module
Q
Enter code number 00001
(0-32000)
-
Press -Q- button to confirm input.
Indicated on display: (Values displayed here are examples only!!).
6X0953257 IMMO
->
Coding 00001 WSC 00000
-
Press -> button.
Indicated on display:
Rapid data transfer
HELP
Select function XX
Tester is now in function selection mode.
Immobilizer III with control module data exchange via "W"Circuit, coding control module
On Immobilizer III systems with control module data exchange via the "W"circuit, the control module for immobilizer has automatic recognition of the
baud rate and coding the control module is not necessary.
The correct data transmission speed between the Engine Control Module (ECM) and the control module for immobilizer is automatically stored in the
control module for immobilizer once recognized.
NOTE: Where applicable, the baud rate is indicated in measuring value block 001: Read measuring value block. See: Scan Tool Testing and
Procedures/Measuring Value Blocks (function 08)