Eurovan MV V6-2.8L (AXK) (2002)
/Page-178003.png)
-
Disconnect the 3-pin connector from Camshaft Position (CMP) sensor 2 -G163-.
-
Use adapter cables from VAG1594 to connect multimeter for voltage measurement to terminals 1 (B+) and 3 (Ground -GND-) of connector for
Camshaft Position (CMP) sensor.
-
Switch ignition on. Specification: at least 4.5 V
-
Switch ignition off.
If there is no voltage:
-
Connect VAG1598/31 test box to control module wiring harness. Engine Control Module (ECM) is not connected.
