Eurovan MV V6-2.8L (AXK) (2002)
/Page-1216001.png)
Control Arm: Specifications
Notes:
^
If it should be necessary to move a vehicle whose drive axle has been removed, then before doing so install an outer joint in place of the drive axle
and tighten it with 50 Nm, or else wheel bearing will be damaged.
^
Specified values for wheel alignment, refer to Alignment, Specifications.
^
Welding and straightening work on supporting or wheel carrying components of the front suspension is not permitted.
^
Always replace self locking nuts.
^
Always replace corroded bolts/nuts.
1 - Hexnut, tighten to 160 Nm
3 - Hexnut, tighten to 25 Nm
7 - Hexnut, tighten to 100 Nm
11 - Hex bolt, 100 Nm
12 - Cylinder bolt
^
80 Nm +90° (1/4 turn)
^
Always replace after disassembly
14 - Hex bolt 200 Nm
^
Always replace after disassembly
17- Hex bolt, 55 Nm
