Eurovan MV V6-2.8L (AXK) (2002)
Downshift Switch: Service and Repair
Kick-Down Shift Point, Adapting
Kick-Down Shift Point, Adapting
Vehicles with automatic transmission must have the kick-down shift point re- adapted after the Engine Control Module (ECM) is replaced and after the
accelerator pedal is replaced.
Test requirement
-
Ignition switched on, engine not running
Test sequence
-
Connect VAG1551 scan tool (VAG1552). Then switch ignition on and select the Engine Control Module (ECM) using address word 01.
Connecting scan tool and selecting ECM.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -4- to select "Basic Setting" function 04. Press -Q- button to confirm input.
Indicated on display:
Basic Setting
HELP
Enter display group number XXX
-
Press 0, 6 and 3 for the function "display group number 63", and then press Q to exit from input mode.
Indicated on display:
System in basic setting 63
->
1
2
3
4
-
Observe reading in display fields 3 and 4:
Display: Activate kick-down
-
Press the gas pedal down past the kick-down pressure point, as far as it goes.
-
Hold the accelerator pedal at impact for at least 2 seconds.
-
Observe reading in display fields 3 and 4:
Specification: Kick-down ADP running and then
Specification: Kick-down ADP OK
-
If display fields 3 and 4 indicate: Display: Kick-down ERROR
-
End basic adjustment of the engine by pressing the -> key.
-
Press buttons -0- and -6- to select "End Output" function 06. Press -Q- button to confirm input.
-
Check Throttle Position (TP) sensor: