Eurovan MV V6-2.8L (AXK) (2002)
/Page-895003.png)
^
Disconnect wheel bearing housing/lower ball joint bolted connection.
^
Always replace bolts.
^
Remove bolt for left-hand shock absorber/stabilizer bar coupling rod.
^
Disconnect drive axle from flanged shaft.
^
Pull connector -1- from multi function switch -2-.
^
Unbolt pendulum support -1- from transmission.
^
Press drive axle out of wheel bearing housing.
^
Press shock absorber together.
^
Take out drive axle, to do this push engine/transmission slightly forward.
