GLI L4-2.0L Turbo (BPY) (2008)
-
Remove side upholstery:
‹› with rear side airbags --> [ Side Upholstery with Side Airbag ] See: Seats/Service and Repair/Rear Seats.
‹› without rear side airbags --> [ Side Upholstery without Side Airbag ] See: Seats/Service and Repair/Rear Seats.
-
Remove the two bolts - 1 - (8 Nm) and remove the anchor point - 2 -.
-
Remove the securing clip - 3 -.
-
Remove bolt - 8 - (4.5 Nm) and remove coat hook bracket - 7 -.
-
Pull the trim - 6 - inward - arrow A - out of the retainers in the body.
-
Pull the trim - 6 - forward - arrow B - over the backrest lock bracket - 4 - and tie-downs - 5 -.
-
Depending on vehicle equipment, disconnect the corresponding wiring harnesses and remove trim from vehicle.
Installing
To install, perform the steps used for removal in reverse order.
‹› Before installing, inspect the securing clips for damage and replace if necessary.