GLI L4-2.0L Turbo (BPY) (2008)
If the value jumps to approx. 140.0° C
-
End diagnosis and switch the ignition off.
-
Replace the Engine Coolant Temperature (ECT) Sensor (G62)
If indication remains at approx. -40.0° C:
°Testing if display approx. 140.0 C
-
Disconnect the Engine Coolant Temperature (ECT) Sensor (G62) electrical harness connector - arrow -.
If indication jumps to approx. -40.0° C:
-
End diagnosis and switch ignition off.
-
Replace the Engine Coolant Temperature (ECT) Sensor (G62)
If indication remains at approx. 140.0° C:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J220). Refer to --> [ Engine Control Module ] See: Powertrain Management/Computers