GLI L4-2.0L Turbo (BPY) (2008)
/Page-371004.png)
‹› If the pin does not fit into the notch: Remove the chain and place the chain on again.
-
Tighten the new camshaft adjuster bolt. To do so, use the (T40080).
-
Remove the (T10115) - arrow B -.
The rest of the assembly is basically a reverse of the removal sequence.
-
Install the high pressure pump. Refer to --> [ High Pressure Pump ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Removal and Replacement/High Pressure Pump.
-
Note the tightening sequence for the cylinder head cover. Refer to --> [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service
and Repair.
