GLI L4-2.0L Turbo (BPY) (2008)
/Page-464004.png)
‹› Tightening specification: 15 Nm + 90° (1/4) additional turn
‹› Note the different length of bolts, refer to --> [ Balance Shaft Gear Bolt Allocation ].
-
Turn the crankshaft to set cylinder 1 at Top Dead Center (TDC).
-
Set the mark on the balance shaft chain sprocket - arrow - opposite alignment bore. Secure the chain sprocket in this position using the (T10027).
Place the chain onto the balance shaft chain sprocket.
