GLI L4-2.0L Turbo (BPY) (2008)
^
Remove adhesive protection ribbon from harness.
^
Center harness according to guides, and join the parts.
Extend ends of harness over the headliner, apply 3M(TM) 08088 General Trim Adhesive (see supplier recommendations).
Tip:
The gap between the harness and the headliner should not exceed 8 mm (.31 in.).
Diagram shows general mounting points of harness to headliner. Harness routing may vary due to vehicle options.
Install headliner. Refer to Technical Bulletin, Headliner, Grab Handle & Sun Visor, Installation Tips, ElsaWeb document ID 2013840.