GLI L4-2.0L Turbo (BPY) (2008)
/Page-1268014.png)
NOTE:
-
Always be sure to use the correct crimping slot for the crimping connection used.
-
Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.
-
Put Shrink Tip For Hot Air Gun VAS 1978/15 on to Hot Air Gun, 220 V/50 Hz VAS 1978/14.
-
Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.
CAUTION:
-
When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot
nozzle of the hot air gun.
-
Always observe operating instructions of heat gun.
