GLI L4-2.0L Turbo (BPY) (2008)
Fuel Gauge Sender: Removal and Replacement
Fuel Level Sensor
‹› Phased-in introduction of fuel delivery units with a changed fuel level sensor.
Removing, Old Version
-
Remove the fuel delivery unit. Refer to --> [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair/Procedures/Fuel Delivery Unit.
-
Release the electrical connectors - arrows - and remove the electrical wires - 1, 2 and 3 -.
-
Lift the retaining tabs - 4 and 5 - using a screwdriver and pull the fuel level sensor downward and off in the - direction of the arrow -.
Installing, Old Version
-
Install the fuel level sensor into the guides on the fuel delivery unit and press up until engagement.
-
Connect the electrical connectors and check for secure locking.
-
Install the fuel delivery unit. Refer to --> [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair/Procedures/Fuel Delivery Unit.
Removing, New Version
-
Remove the fuel delivery unit. Refer to --> [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair/Procedures/Fuel Delivery Unit.
-
Pull the fuel level sensor slightly to the side and simultaneously upward.