GLI L4-2.0L Turbo (BPY) (2008)
/Page-557003.png)
-
Insert a screwdriver - A - between protective housing and retaining plate - arrow -
-
Pry protective housing upward using screwdriver - A - and pull it off sideways from retaining plate - arrow -.
-
Disengage forward harness connector - 1 - from Engine Control Module (ECM) and disconnect it.
-
Pry up locking mechanism - 2 - slightly.
-
Then slide Engine Control Module (ECM) out of retainer - arrow -.
-
Now disengage rear harness connector from Engine Control Module (ECM) and disconnect it.
Installing
-
Connect rear harness connector to Engine Control Module (ECM) and engage it.
-
Slide Engine Control Module (ECM) on to retaining plate.
