GLI L4-2.0L Turbo (BPY) (2008)
-
Remove the Motronic Engine Control Module (ECM) J220 from the retainer - arrow -.
-
Disconnect the rear electrical harness connector.
Installation
Installation is performed in reverse order of removal. Note the following:
-
Reprogram the Motronic Engine Control Module (ECM) J623.
Motronic Engine Control Module (ECM) J220 with Antitheft immobilizer, removing and installing
-
Remove the wiper arms.
-
Remove the plenum chamber cover.
-
Saw off two rounded sides of the shear bolt heads so that two flat parallel surfaces result - arrows -.
-
Using locking pliers, remove the shear bolts. Discard the shear bolts.
-
Insert a screwdriver - A - between the protective housing and the retaining plate - arrow -.