GLI L4-2.0L Turbo (BPY) (2008)
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J220). Refer to --> [ Engine Control Module ] .
-
Using a Multimeter, check the Selector Lever Sensor System Control Module (J587) electrical harness connector to the Motronic Engine Control
Module (ECM) (J220) electrical harness connector T94 for resistance.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
If necessary, repair the faulty wiring connection.
-
Erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to --> [ Readiness Code ] See: Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes.
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Selector Lever Sensor System Control Module (J587).
After the repair work, the following work steps must be performed in the following sequence:
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to --> [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to --> [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.