GLI L4-2.0L Turbo (BPY) (2008)
-
Remove mounting nut - 1 -.
-
Remove the mounting bolt - 2 - and remove the Left Front Level Control System Sensor G78 - 3 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten all fasteners to specified values.
-
Check the Left Front Level Control System Sensor G78.
-
Perform basic setting of headlamp.
NOTE:
-
If the Left Front Level Control System Sensor G78 Left Rear Level Control System Sensor G76 is replaced, check the values and perform
basic setting on the headlamps.
-
Headlamp basic setting cannot be performed if the values for the Left Front Level Control System Sensor G78 Left Rear Level Control System
Sensor G76 are outside of the tolerance.