GLI L4-2.0L Turbo (BPY) (2008)
Checking voltage supply and wiring
-
Switch the ignition on.
-
Using a Multimeter, check the following wiring connections for voltage.
-
Switch the ignition off.
If the specification was not obtained:
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J220). Refer to --> [ Engine Control Module ] .
-
Using a Multimeter, check the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185) electrical harness connector
terminals to the Motronic Engine Control Module (ECM) (J220) electrical connector T94 for an open circuit.